- Published on
1. Basic frame
The base frame consists of two (2) lower side rails, several cross members and a gooseneck tunnel, which are welded together as a subassembly.
2.Front End
The front end will be composed of corrugated end wall and front end frame,
which are welded together as a sub-assembly.
3. Rear End
Rear end is composed of Rear End Frame which consists of one door sill, two
corner posts, one rear header with header plate and four corner fittings, which
are welded together as a sub-assembly, and Door Systems with locking
devices.
4.Side Wall Assembly
Side Walls Each side wall will be composed of a number of sheets for the intermediate (inner) parts and outer panels at each end of side wall, fully vertically corrugated into trapezium section, butt welded together to form one panel by automatic welding.
5.Roof
The roof will be constructed by several die-stamp corrugated steel sheets with a certain upwards camber at the center of each trough and corrugation, these sheets are butt jointed together to form one panel by automatic welding.
The base frame consists of two (2) lower side rails, several cross members and a gooseneck tunnel, which are welded together as a subassembly.
2.Front End
The front end will be composed of corrugated end wall and front end frame,
which are welded together as a sub-assembly.
3. Rear End
Rear end is composed of Rear End Frame which consists of one door sill, two
corner posts, one rear header with header plate and four corner fittings, which
are welded together as a sub-assembly, and Door Systems with locking
devices.
4.Side Wall Assembly
Side Walls Each side wall will be composed of a number of sheets for the intermediate (inner) parts and outer panels at each end of side wall, fully vertically corrugated into trapezium section, butt welded together to form one panel by automatic welding.
5.Roof
The roof will be constructed by several die-stamp corrugated steel sheets with a certain upwards camber at the center of each trough and corrugation, these sheets are butt jointed together to form one panel by automatic welding.